Oak Coffer Observations Part One

I’ve put off writing about this because I was waiting for our shipment to arrive from the UK so I could reference some of this first hand.

One of the types of furniture that I found in the UK that piqued my interest was the oak coffer. Since the middle ages, the oak coffer or oak chest has been an essential piece of furniture for a household and not only served as storage but as a seat. The earlier coffers were primarily plank construction, something that changed during Elizabeth I (1558 – 1603) when panelled coffers became more popular. (English Furniture, Its Essentials and Characteristics by John C. Rogers, Published by Offices of Country Life, 1923)

Beautiful example of a 6 plank oak chest. 16th century. Photo from Antiques Atlas
Showing the long wide single plank top. Photo from Antiques Atlas
A panelled oak coffer from the 16th century (Elizabeth I). Photo from Marhamchurch Antiques
Another Elizabeth I example. Photo from Marhamchurch Antiques

While in the UK, I rarely saw the earlier plank chests (I saw a few later 20th century versions), but I did see quite a few of the panelled chests. Once I started looking at them more closely I realized that they are similar to the oak chests that Peter Follansbee has been talking about for quite some time. When I re-watched an episode of “The Woodwright’s Shop” it really motivated me to look into this type of antique and how they were made. In this episode, Mr. Follansbee had observed that there were grooves in the top of the stiles that didn’t seem to make sense.

In this screenshot we can see that there are grooves on one face of each stile and that they seem to chase each other around the chest. Why is there a groove on only one face? And why on alternating faces?

The groove itself is for the panel to ride in and is only needed between the mortises for the rails. Functionally there would be no reason for the groove to go all the way to the end of the stile. Mr. Follansbee went on to show how the rear portion of the skate (or runner) of the plow plane would ride too high for the iron to cut the groove unless you cut a groove for the skate to ride in.

The plow plane cannot cut the groove for the panel because the back of the skate will ride high. The solution is to cut the groove all the way to the top of the stile so the skate can drop down and let the blade cut.

I had seen this episode many times before but I’d never had a chance to look at any old coffers up close. Since then, I’ve seen dozens and we also own one that was made in the late 17th century (about 1670). I’ve found that many of the panelled construction coffers do show these grooves to some extent, however, the age of these pieces and the fact that many have been repaired at a much later date can wipe out some of these clues.

This chest shows the grooves on three of the stiles. The back left stile does not have a visible groove.

The following are of my coffer that just arrived, so I was able to take better pictures.

Front left stile.
Front right stile.
Rear left stile.
Rear right stile.

It’s been incredibly exciting to be able to find supporting evidence for this process and even more exciting to be able to handle so many of these pieces. I’ll be following up with more on the oak coffer since I’ve found many more interesting things in mine. I’ve also been sorting through my photographs of all the others and continually find new and interesting things.

Oak Coffer Observations, Part Two

You can find the first part of my observations here. I’ve been interested in oak coffers for quite some time. I think it was Peter Follansbee who initially made me aware of them quite a few years ago. While researching green woodworking I came across Mr Follansbee’s website where he talks about early American furniture makers, furniture-making tools, and processes. His website is always informative, inspirational, and extremely valuable when it comes to green woodworking, 17th-century furniture making, tools, and bird watching.

The oak coffer was made almost exclusively with mortise and tenon joinery, although there are a few exceptions to this where dovetails or butted and nailed edges were used. Some later versions were made of walnut and other local wood, but by and large, the earliest coffers were oak and made with mortise and tenon joinery. This put them under the strict control of the Joiners Guild (members of the “Mystery of the Joyners”). This meant that within the City of London (and to varying degrees, elsewhere in England) from the 15th to 17th centuries, the guild had the authority to search workshops. These inspectors would ensure that only members of the guild were making joined products and that the craftsmen who were members followed the guild procedures and processes. The Carpenters and Turners also had guilds, and over the centuries they competed and merged with the others. The history of the guilds in Europe and the UK is fascinating, and I’m sure I’ll go down that rabbit hole and write about it sometime in the near future.

You have been warned.

I had been looking at coffers for quite a while and had my eye on several. One of the first coffers that I had a good close look at was at a Lyon and Turnbull auction in Edinburgh in Nov 2018. This was my first good up-close look at a 17th-century oak coffer, and I was over the moon. My oh so patient wife watched me make a spectacle of myself as I bounced from piece to piece at that viewing, but the 17th-century pieces stole the show for me. Over the next year though, I’d see quite a few other coffers, newer and older and in better and worse shape, and so I ended up being able to make somewhat intelligent comparisons.

The first oak coffer I had a chance to look at up close and personal was at a Lyon and Turnbull auction in Edinburgh.
This piece ended up selling for £375

After almost a year in Scotland and then in England, looking at hundreds (if not thousands) of beautiful old pieces of furniture, and more specifically, oak coffers, we finally found one that fit our needs/desires. While living in March, Cambridgeshire in the UK, we purchased an oak coffer from the Risby Barn Antique Centre near Bury St. Edmunds. Since then, I’ve been slowly going over it to see how it was made, how it had been repaired, where it had lived, and trying to verify its age.

The oak coffer I’ve been studying.

We had allotted up to a certain amount for our purchase, but this coffer that we decided on was well below that. It was sold as an “Early 17th-century plank top oak coffer” and even though I’d seen many of the same age in better condition, this one caught my eye because of the repairs and the newspaper that was used to line the interior. I decided on this one not just because of its beauty but also because of the story it would tell, which to me, is just as important.

As I mentioned, the newspaper lining was one of the first things I noticed that set this one apart from most of the others I’d seen. In fact, after going over all of my pictures I don’t believe I had seen any other ones with newspaper lining so, BIG WIN. There isn’t anything about the paper lining that adds to the monetary value of the piece and more likely, it decreased the value by hiding the interior. But for me, it provides clues to the history of the piece, which is valuable. I’m going to write specifically about the paper lining in a future post, but for this post I’m going to concentrate on the legs and feet and those repairs.

The legs are also the stiles of the panels and house the mortises for the side and front rails. The end grain of the feet have been soaking up any and all moisture on the floors for more than 300 years, and it is quite likely that the first several homes that this piece lived in had dirt floors.

Water and insect damage are visible in this picture.

The back legs have been damaged the most and after reading a bit about this it does make sense.

The back legs would have been up against an outside wall of either stone or wattle and daub (and no insulation or moisture barrier) so moisture and even standing water would not have been uncommon.

In the case of our coffer, the legs had probably deteriorated to the point that the person who repaired it simply had to cut them back to a point where they were not as rotted. That person then added two sections of new wood. The one behind the leg has the grain running vertically. This piece is likely to stabilize and strengthen the leg. The second section was on the bottom of the foot and had the grain running horizontally, so it would not wick as much moisture. This repair may have happened a century or so after it was built, but the next picture shows that the spliced piece behind the leg, as well as the block attached to the bottom, have been worn at an angle. This could mean one of two things. First, it might be that the person who added the repairs made the back legs too long and then cut the back legs at an angle to meet the front legs. I don’t think this is the case, but I could be wrong…Nah, I’m not wrong.

Back foot repairs at an angle.

I think what really happened here is that after the back feet were repaired, the front feet also experienced deterioration that resulted in them losing a bit off the ends over the centuries. As the front feet wore down, the back feet wore at an angle to compensate. One other thing I’ve noticed is that the vertical piece that was scabbed onto the back of the leg may not be nearly as old as the horizontal piece added to the end of the foot. This because that piece doesn’t show any of the deterioration that you would expect if it had been soaking up moisture for several centuries.

Not a great picture, but you can see that the end grain of the scabbed piece is not deteriorated.

This possibly means that the scabbed piece was added after the coffer moved to a home with non-dirt floors, thereby not wicking up as much moisture over the next hundred or so years.

For the next part of my observations, I’ll talk about the newspaper lining and how that fits into the piece’s history.

Oak Coffer Observations Part 2.5

I was talking about the legs of our coffer and how they had been worn down and cut down over the centuries, and I wanted to show just how much that is.

This first is our coffer with its stubby – or shapely – legs. You can see that the front legs are uneven.

And below you can see that the back legs are quite a bit shorter than the front.

Now I have a couple of beautiful examples of coffers (just as old as ours) with nice long and even legs. The following pictures are all from Peter Bunting Antiques.

17th century coffer with a paneled top and nice long legs and relatively little moisture damage.
17th century coffer with some long legs that do show moisture damage. Conservation will keep these from deteriorating any further.
A beautiful 16th century 6 plank coffer. You can see the back right leg has a repair, but still has its length.

I think this says quite a lot about the homes that our coffer lived in for a good portion of its life. Dirt floors covered with loose rush (or woven rush) were common in England up until the 18th century (and maybe later). In fact, one of the reasons for the low stretcher on the front of early chairs (back stools) was so the person could put their feet on them and not have to leave them in the wet and dirty rush covering the floors. When we see these chairs with the stretcher almost touching the floor, this is only after the legs have been rotted and chopped off.

Back on topic. I’ve added these clues to my list and will talk about the clues I found in the newspaper lining next.

Oak Coffer Observations, Part Three

This post continues from my previous. One of the things about this piece that caught my eye was the newspaper lining. At first, I wasn’t sure what it was because I was mostly interested in the exterior carving, patina, damage, and hardware. But after we got it home (our place in March, Cambridgeshire) I was able to take a closer look at the interior and realized that my hunch was right, and the newspaper lining was probably old as well.

The first thing I did was try to find a date, which ended up being September 21, 1872. I found a couple of other pages with the same date, so it is probably all the same issue of the same newspaper.

I then started looking at the layout of the newspaper within the coffer and realized that it was used not only to protect the contents of the coffer from snagging on the wood but also as a bit of decoration. This coffer was already 200 years old when the owners decided to line it so it’s likely that splinters and ragged edges would have ruined any fabrics that were stored inside.

I also found where the newspaper was from. Norwich, in Norfolk.

We purchased the coffer near Bury St. Edmunds, which is about 40 miles as the crow flies from Norwich, so in its 300 plus history, it probably didn’t stray far from where it was made.

The coffer was likely made in the mid to late 1600s, although there is no provenance and the construction methods did not change significantly between the 1400s and the 1700s except to include other woods like walnut or pine.

In the next post I’ll talk more about how the coffer was built.