Small elm bedside stand, Part 4

Posted on by

Ok, so it’s been a while since I’ve made any progress on the stand, but I have a very good excuse…and that’s a bald-faced lie. I have been working on our home remodel, but I’ve also started a few other projects so I’ve just been pretty distracted.

I decided to replace the bottom because the previous bottom (which was also a replacement) was too warped to fix.

This is the previous bottom, which was also a replacement. It was a nice thick piece of pine, but it twisted and warped so badly that I wasn’t even tempted to try to fix or straighten it.

I had some nice pine that I’m using for another project. The pieces were too narrow so I joined them and cut them to length.

The new piece was too thick so I got the scrub plane out and took off about 3mm (1/8th inch) from the face, then flattened and smoothed the face.

Using my scrub plane.
And following up to smooth the face.

I dry fit the bottom into the grooves in the legs and clamped it up to make sure the bottom was not too wide or deep.

After some tweaking. Shaved down the edges and sides so it fits snuggly but has room to expand. In this case the bottom will expand to the sides.

I’m pretty happy with the bottom and I’m ready to start glueing up the carcase. That will be in the next post.

Leave a Reply

Your email address will not be published. Required fields are marked *

2 × three =

This site uses Akismet to reduce spam. Learn how your comment data is processed.